Motorcycle driving skills
It is not easy to become a better motorcycle rider. First of all, we must master the correct driving posture. Regardless of the car, the driving posture is very important. So what should be done to better ride a motorcycle? The posture must be correct and maintain the balance of the body. Do not be nervous when riding a bike. Your body should not be too rigid. Hand-hold your hands gently. Do not press the handlebars very hard. This way you can't handle the steering wheel well by pressing the handlebars. . The two hands not only need to control the steering wheel, but also need to control the clutch, the turn signal, and the brakes of the vehicle. So the whole body's relaxation is the key. While maintaining the balance between the body and the car, it is also possible to change the sitting posture according to its own comfort. For example, tilting the body as the vehicle turns makes a changeable posture. When the motorcycle is running normally, the body is sitting naturally in the car. The spine of the upper body is arched, and the buttocks sit in a comfortable position. Do not go too far or sit too far behind. The two elbows are bent, the chin is recovered, and the front is visible. When the body is leaning forward, do not hold the weight of your body with your hands. The body's center of gravity falls on the lower body so that the direction can be flexibly turned. When riding a motorcycle, the leg is not in an open state, and the fuel tank can be clamped gently. It is necessary to keep the lower body in line with the motorcycle. When the motorcycle is turning, it is necessary to move the lower part of the body to maintain balance with the car. The feet should naturally be placed on the pedals on both sides of the car. The brake handle of the motorcycle is controlled by the middle finger, ring finger, and index finger. The rest of the fingers hold the handlebar to facilitate turning the throttle. When starting the motorcycle engine, hang the motorcycle's gear to neutral. Turn on the power switch, the best time to start the electric starter motorcycle is not more than three seconds. If you have problems starting, you should wait a little while. Do not increase the throttle immediately after starting the engine. The engine should be driven before the engine temperature rises. Otherwise, it is easy to damage the engine.
Someone may not clear that it would change the time, resulting in poor engine performance even damage to valves, if the teeth on the belt jump over the teeth of gear. So that`s why tensioner Bearing exists. It keeps belt tension never be too low or too high.
The tensioner bearing should be replaced when replacing the timing belt. And we are professional for the United States, Europe, Japan and other countries, to provide high quality and affordable tension bearing.
belt Idler Pulleys are provided with a series of radial reinforcing ribs to prevent deformation caused by the wedging action of the belt.
The timing belt tensioner is used to keep tension on the timing belt. The timing belt is a rubber belt that runs over and through a series of pulleys and gears. Over time, due to age and heat, the belt will stretch out. As the belt stretches it can become loose, so the tensioner needs to adjust the belt as needed to keep it tight.
Tensioner Bearing,High Strength Tensioner Bearing,Tensioner Roller Bearing,Belt Idler Pulley,Timing Belt Tensioner NINGBO DGOFEN AUTO TRADE CO., LTD , https://www.dgofen.com