Electromagnetic Shaker Installation Procedures and Features
Dryer Parts,Aluminum Dryer Housing,Dry Housing Aluminum Casting,Aluminum Casting Dryer Housing Shandong Newels International Co., Ltd , https://www.newelsindustrial.com
1. First, fix the four foot bases of the table body to the places to be placed.
2, if you want to be fixed on the worktable, it is best to use angle steel to make a work table, desktop requirements level.
3. Connect the input line of the electromagnetic vibration table body to the output hole of the control box.
1 body height 15cm vertical 2 body height 25cm level 4, then control box power supply 220∨/50HZ
5. Turn on the power switch, select the waveform as full wave, and select the vibration direction (vertical).
6, according to "two, set steps" to enter the parameter settings.
7, according to "three, frequency operation instructions" to adjust a single group or sweep frequency and other functions.
8, fine-tune AM fixed in the middle position. Press “6. Amplitude modulation control description†to adjust the amplitude.
9. Press the start button to start the vibration test.
Electromagnetic shaker features:
1Using the electromagnetic loop self-loop to generate high-inductance 2 using overlapping winding/generating pull-in action 3 in/out of the same loop, leaving only 2 ends, when the current is in accordance with the left-hand law, due to the inductance of the laminated cooperative inductor, It also generates high exciting force, and achieves a fixed suction action 4 suction electromagnetic vibration table: Components:
a: high-inductance electromagnetic coil b: ultra-high-inductance silicon steel sheet -E/lower sheet, I/top sheet generator c: spring steel sheet: special treatment d: support frame 5 will not be subject to quality changes, change load or exciting force (Dongguan City Haoen Detection Instrument Co., Ltd.)
6Because of the countertop/base/supporting frame/spring steel plate, it is integrated with the electromagnetic coil, which can effectively improve the uniformity and stability, free from the restriction of irregular objects, cause unevenness and stability of the center point, and reduce the cost of the fixture 7 vibration. : The center horizontal line is 0, and the vibration goes up and down. It really meets the requirement of the amplitude amplitude mm(pp). It solves the shortcomings of the high-frequency circular electromagnetic vibration table 8 Real solution: Each high-frequency electromagnetic vibration table is difficult to solve (at 50Hz Hours/5mm/20g/100kg Weight) Unaffected Technology