Wireless bridges are autonomous LANs and have software debugging issues. Different manufacturers, software debugging instructions are also different. And the wireless bridges of Lai'an Company are basically debugged before leaving the factory. In other words, it can be used basically, but some of them will need to be reconfigured according to the specific situation. Here's a simple debugging instruction.
First, the wireless bridge device debugging needs to enter the software debugging interface of the device through IE browser or a third-party browser (such as 360 browser, Sogou browser, etc.). Gu Ge browser is recommended here. Some browsers are incompatible and easy to debug. First, you need to change the IP address of the local computer. Make sure that the IP address of the device is on the same network segment as the IP address of the local computer. The specific operation is as follows: Open the "Control Panel" → "Network and Sharing Center" → "Change Adapter Settings" → " "Local connection" → "Properties" → "Internet Protocol Version 4 (TCP/IPv4)" Manually set the computer's IP address.
Second, after setting the IP address, enter the IP address of the device in the browser's address bar. Since the first time you enter the debug interface of the bridge device, after the device IP address is entered, the browser may not directly pop up the login interface of the device. An English prompt will appear on the main interface of the browser (Press “Reboot†after all configurations to Enable new setting). For this phenomenon, there is no need to suspect that it is a device problem or a computer problem. The reason for this problem is usually to use a third-party browser to cause compatibility problems. At this time, you only need to click the right mouse button in the browser's address bar to switch between browser modes (compatibility mode or extreme speed mode).
Third, correctly plan the IP address of the wireless bridge. Wireless transmission systems built using wireless bridges will use a large number of IP addresses. To avoid conflicts between IP addresses of wireless bridge devices and other devices on the LAN, there are two main solutions: First, separate the networks. Separate the wireless transmission network formed by wireless bridges from other networks (such as office networks and server networks) and use a single core switch. Second, re-plan the IP addresses of devices. Divide the IP address of the wireless bridge device and the network camera and hard disk recorder IP address in different network segments.
Glass Fiber Filter Element is a new type of liquid Filter Element and air purification filter element made of composite glass fiber film as filter medium. It has excellent performance and wide use. Glass fiber Filter element has a small pressure and large dirt holding capacity , which can effectively adsorb the suspended matter in filtrate.
Glass Fiber Filter Element
Oil Filter Element,Composite Glass Fiber Filter Element,Glass Fiber Oil Filter,Glass Fiber Filter Element
Xinxiang Tianrui Hydraulic Equipment CO.,LTD , https://www.filterelement.pl